| Fiero Forum |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| Need some Fiero Advice? Have some Fiero advice or tips to share? Post them here by filling out the form below. They will be posted after review and deleted periodically |
Info Needed: I have a 1986 SE. My converter splash
shield is dragging. How important is this shield? Can I
simply remove it or must I replace/repair it? Where can I
get a new one if I have to replace it?
Contact Tony at revsikora@juno.com 3-10
shield is dragging. How important is this shield? Can I
simply remove it or must I replace/repair it? Where can I
get a new one if I have to replace it?
Contact Tony at revsikora@juno.com 3-10
Info Needed: I have an 88 Gt with a swelled rear lower
inlet hose. I have tried to locate one but no one carries
the 88 hose. Could anyone direct me to where I could
locate a hose or tell me if there are any alternative flex
hoses that will work?
Contact Bob at fourhearts4@comcast.com 4-10
inlet hose. I have tried to locate one but no one carries
the 88 hose. Could anyone direct me to where I could
locate a hose or tell me if there are any alternative flex
hoses that will work?
Contact Bob at fourhearts4@comcast.com 4-10
Info Needed: I have replaced the entire shifter assembly
on my pace car and can't get the knob low enough to
replace the u clip in the knob. Can someone tell me the
secret?
Contact Kevin at ka_roy@hotmail.com 5-10
on my pace car and can't get the knob low enough to
replace the u clip in the knob. Can someone tell me the
secret?
Contact Kevin at ka_roy@hotmail.com 5-10
Info Needed: Accelerator cable. Pedal is hard to push. Is
it hard to get at cable to replace or lube it? Is it hard to
take the center console apart to access the cable?
Contact Jerry at jhobson@sbcglobal.net 6-10
it hard to get at cable to replace or lube it? Is it hard to
take the center console apart to access the cable?
Contact Jerry at jhobson@sbcglobal.net 6-10